Watlow Series V4 - Manual (Page 5)

Installation and Removal (continued)
Figure 5a - Slightly compress the case while Figure 5b - Snap the top and bottom mounting
pulling the controller into the panel cutout. bracket into the slots.
Figure 5c - Tighten screw to secure the controller. Figure 5d - Remove the controller using a flat
screwdriver.
NOTE: Be careful not to over-tighten the screws. This may cause the mounting cover to fail. Over-tighten-
ing occurs when the front bezel is touching the customer’s front panel.
Removing the Series V4 Controller
1. Loosen the upper and lower mounting bracket screws.
2. Use a flat screw driver to unsnap the four grips on the opposite side of upper and lower
mounting brackets. Push the brackets back and forth gently until they can be pulled off easily.
3. Remove controller from the panel.