Wright Serial 54956 and higher - Manual (Page 13)

13
2 Warning, Safety and Instructional Decals
•
Specific safety warning decals are located on the equipment near immediate areas of potential
hazards.
•
Keep all safety signs legible. Remove all grease, dirt and debris from safety signs and
instructional decals.
•
Replace worn, damaged or missing safety decals.
•
If an attachment or accessory has been installed, make sure current safety decals are visible.
1. Throttle, Slow/Idle
2. Throttle, Fast/Full
3. Blade Engage/Disengage
switch
4. Ignition Switch, Off
5. Ignition Switch, Start/Run
3 Specifications
Engine
•
See your engine owner’s manual
•
RPM: Full speed 3600 +/- 50 RPM (no load) / Idle 1550 RPM
Electrical System
•
Charging System: Internal stator coil
•
Battery Type: N/A, Recoil Start
•
Battery Voltage: N/A
•
Fuses: N/A
Fuel System
•
Capacity: 5.6 gal.
•
Type of Fuel: Unleaded regular gasoline, minimum 85 octane. Do not use gasoline
containing more than 10% ethanol. Do not mix oil with gasoline.
•
Fuel Filter: In line
•
Fuel shut-off: On, Off located on tank
Dash Decal
76490056
2
3
4
5
76490001 DECAL,
SHIELD MISSING
76460001 DECAL, DANGER
BLADE HAZARD