Wright Serial 54956 and higher - Manual (Page 22)

22
6.2.2 Replacing the Cutter Deck Belts
•
Stop the engine, remove the key and wait for all moving parts to stop.
•
Lower deck to the lowest setting.
•
Remove the deck covers.
•
Remove the belt by using a ½” ratchet and extension to relieve the belt tension.
•
Reinstall in reverse order. Figure shows belt routing and spring compression direction.
6.3 Lubrication
Grease with No. 2 general purpose lithium base or molybdenum base grease.
•
Set parking brake, stop the engine and remove the key.
•
Clean grease fittings with a rag.
•
Connect grease gun to fitting and pump until grease begins to ooze out from the bearings.
•
Wipe off excess grease.
•
Do not use spray lube of any kind on choke and/or throttle cables.