Wright Serial #59542 and higher - Manual (Page 17)

15
4.3 Steering Control Levers
The ZTO’s speed and direction are controlled by using two steering control handles. The handles can be
moved forward and backward about a neutral position. Moving the control handle equal distance forward or
backward the machine moves in a straight line.
4.4 Fuel System / Shut Off Valve
The fuel shut off valve is located at the left rear behind the
seat compartment. The fuel valve should be in the “Off”
position at all times when the mower is not in use. Do not
fill fuel tanks completely. Fill until level is 1 inch below the
bottom of the white fill neck insert. This will allow for the
gas to expand and prevent fuel from soaking the vent
valve. A fuel gauge is located on the left tank. Use the
fuel from the right tank first. When the right tank is empty, switch to the left tank. The fuel gauge will monitor
the remaining fuel.
4.5 Seat
The seat is equipped with a seat belt, Flip-up armrests, forward and
rearward adjustment.
•
Forward and Rearward Adjustment – Located under the right
front side of the seat, pull the lever to the side, slide seat
forward or backward.
4.6 Digital Hour Meter
The ZTO is equipped with a digital hour meter. Refer to operating/reset instructions below.
The programming specified is:
Default display: Hours
Press once (TMR1): Timer 1, press for 3 sec to reset
Press twice (TMR2): Timer 2, press for 3 sec to reset
Press three times (svc ENG): Will display time remaining until next
service point, hold down to reset. The first interval is 8hr, thereafter
100hr. Beginning 5hr before service point the meter will flash “svc ENG,
in [remaining hours]” every 5 sec.
Shut off engine: Will display how many times the engine has started.
Inward Drive
Position
Right Turn
Left Turn
Left
Tank
Off
Right
Tank