Yokogawa EJA440E User Manual
Dpharp brain communication type
Advertising
Table of contents
Document Outline
- 1. Introduction
- 2. Connection
- 3. Operation
- 3.1 BT200 Operating Procedures
- 3.2 Setting Parameters Using the BT200
- 3.2.1 Parameter Usage and Selection
- 3.2.2 Menu Tree
- 3.2.3 Setting Parameters
- (1) Tag No. Setup
- (2) Calibration Range Setup
- (3) Damping Time Constant Setup
- (4) Output Mode and Integral Indicator Display Mode Setup
- (5) Output Signal Low Cut Mode Setup
- (6) Integral Indicator Scale Setup
- (7) Unit Setup for Displayed Temperature
- (8) Operation Mode Setup
- (9) Impulse Line Connection Orientation Setup
- (10) CPU Failure Burnout Direction and Hardware Write Protect
- (11) Software Write Protect
- (12) Output Status Setup when a Hardware Error Occurs
- (13) Bi-directional Flow Measurement Setup
- (14) Range Change while Applying Actual Inputs
- (15) Sensor Trim
- (16) Test Output Setup
- (17) Signal Characterizer
- (18) Process Alarm
- (19) Status Output (option code AL)
- (20) Capillary Fill Fluid Density Compensation
- (21) Adjustment Information and User Memo Fields
- 3.3 Displaying Data Using the BT200
- 4. Self-diagnostics
- 5. Parameter Summary
- Appendix 1. Safety Instrumented Systems Installation
- A1.1 Scope and Purpose
- A1.2 Using the Transmitter for an SIS Application
- A1.2.1 Safety Accuracy
- A1.2.2 Diagnostic Response Time
- A1.2.3 Setup
- A1.2.4 Required Parameter Settings
- A1.2.5 Proof Testing
- A1.2.6 Repair and Replacement
- A1.2.7 Startup Time
- A1.2.8 Firmware Update
- A1.2.9 Reliability Data
- A1.2.10 Lifetime Limits
- A1.2.11 Environmental Limits
- A1.2.12 Application Limits
- A1.3 Definitions and Abbreviations
- Revision Information