Redundant switch controller, Remote monitoring (rmon), Simple network-management protocol (snmp) – Avaya P880 User Manual

Page 25

Advertising
background image

25

610-0184-095

June 14, 2001

■

If a router port for intelligent multicasting is mirrored with a
piggyback port, the piggyback port is listed instead of the
router port.

Redundant Switch Controller

The following problem has no workaround:

■

Do not enable redundancy unless you have a redundant
switch controller.

■

On a P880 with an 80-series supervisor module, the
redundant switch controller may not take over when the
active switch controller fails.

Remote Monitoring (RMON)

The following problems have no workaround:

■

30 minute RMON statistics always show utilization as 0
(Zero) on a heavily used Gigabit Ethernet port.

■

Statistics for unicast frames do not work when using
multilayer (ISL) tagging.

Simple Network-Management Protocol (SNMP)

The following problems have no workaround:

■

Cold start traps cannot be transmitted out of inband
interfaces after you enable Spanning Tree.

■

ipAddrTable does not display inactive interfaces (VLANs). An
inactive interface occurs when there are no active ports on a
VLAN.

Problem:

■

If you use the CLI to perform either of the following
commands, the supervisor module stops responding and
resets:

—

snmp walk aarpNetAddress

—

snmp walk cjnAtEchoSend

Workaround:

Use SNMP from a management station to access these MIB items.

Advertising