Avaya P880 - Manual (Page 38)

610-0184-095 A-4 June 14, 2001
Examples
■
To display the settings of all of the ports on the module in slot
3, enter:
show port 3
■
To display the settings of ports 1 through 5 on the module in
slot 3, enter:
show port 3/1-5
■
To display the settings of ports 1 through 5 on the module in
slot 3 and of port 1 on the module in slot 6, enter:
show port 3/1-5,6/1
Setting a Rule in an Access Control List
Command
Use the access list command to set a rule on an access control
list. The rule that you set will be applied on all of the ports on the
switch. The command syntax is:
* Note: You must enable the access control list on which you want
to set a rule. Only one access control list can be enabled at
a time.
> configure)# access-list <access-list-name>
<access-list-index>
{permit|deny|fwd1|fwd2|fwd3|fwd4|fwd5|fwd6|fwd7|
fwd8} <protocol-id> {<source-ip-addr> <source-
wildcard>|any|host <source-ip-addr>}
[{lt|eq|gt|range} <port> [<port>]] {<dest-ip-addr>
<dest-wildcard>|any|host <dest-ip-addr>}
[{lt|eq|gt|range} <port> [<port>]] [established]