MAHLE RTI TX200-UNDP - Manual (Page 5)

Page 4
RECOVERY MODE
Figure 1 shows the recommended connection of the TX200 to an A/C System.
CAUTION...
The hose from the A/C System must be connected to the LIQUID VALVE of the DOT Cylinder. The Hose
from the DOT Cylinder to the External Disposable Filter (EDF) must be connected to the VAPOR VALVE of
the DOT Cylinder. This prevents introduction of large quantities of liquid refrigerant, oil and acid into the
TX200 which could damage the Compressor.
Do not depend on the colors of the Valve Knobs to indicate Liquid or Vapor. Always check the embossed
printing on the knobs.
The ERC Cylinder must have an Overfill Protection (OFP) Device.
Disconnect Power Cord from power source while connecting the OFP (Overfill Protection) Device to avoid
bodily injury due to electrical shock.
Connect Yellow Cable from TX200 to OFP Device on ERC Cylinder.
Do not force plug into OFP Device. Look at pins in plug and align them with sockets on OFP Device.
Figure 1 TX200 Connection For Recovery