MAHLE RTI Laser 4 - Manual (Page 11)

Page 11
PRINTER OPERATION
Alignment data is recorded in the Data Accumulator during the alignment procedure as described in
the following pages. This data is then transferred to the printer and a printout is generated. Following
are the steps to generate a printout:
1 Connect the Data Accumulator to the Printer as shown on Page 6.
2 Connect the printer to an appropriate power source. Turn the Printer on (power switch is on
rear). The green POWER indicator will be illuminated.
3 Press the SEL key on the Printer to place it online. The green SEL indicator will be
illuminated.
4 Press the PRINT key. The display will indicate “USE DEFAULT SPECIFICATIONS?” with
the option of 1. YES or 2. NO. Select NO by pressing the 2 key.
NOTE: If YES is selected, the printout will show that default specs were selected and print
Left Camber of -00.50, Right Camber of -00.40, and Total Toe of -00.15.
5 The display will indicate “ENTER REPAIR ORDER #”. The arrow keys can be used to enter
a customer specific number such as the work order number. The up and down arrows scroll
through the alpha-numeric characters and the right and left arrows move the cursor. Press the
ENTER key after the information has been entered.
6 The display will indicate “ENTER MAKE OF VEHICLE”. Use arrow keys as above and press
ENTER key after information has been entered.
7 The display will indicate “ENTER MODEL OF VEHICLE”. Use arrow keys as above and
press ENTER key after information has been entered.
8 The display will indicate “ENTER YEAR OF VEHICLE”. Use the number keys to enter
the year (the up and down arrow keys do not function in this step). A year must be
entered. Use the right and left arrow keys to move the cursor. Press the ENTER key after
information has been entered.
9 The display will indicate “ENTER TYPE OF VEHICLE”. Use arrow keys as above and press
ENTER key after information has been entered.
10 The display will indicate “PRINTING” as the printer generates the printout.
11 The display will indicate “CLEAR?” with the options of 1. YES or 2. NO. Press the 2 key if
another printout is desired, otherwise, press the 1 key.
12 Turn the Printer off and disconnect the Data Accumulator.