Battery replacement – MAHLE RTI Laser 4 User Manual
Page 29
Page 29
BATTERY REPLACEMENT
The Laser 4 is powered by eight “C” batteries; four batteries located in each Toe Gauge. Alkaline
batteries are recommended for extended life.
The batteries should be replaced when the laser beam image becomes dim or can no longer be seen.
Laser Toe Gauge Battery Replacement (See Figure 46):
1)
Flip the Laser Toe Gauge switch to OFF.
2)
Place the Laser Toe Gauge on a workbench with the underside of the casting facing up.
3)
Loosen the battery cover locking knobs and open the cover.
4)
Replace the batteries following the diagram in the battery holder. Flip the switch to ON to be sure
the laser diode operates. Flip the switch to OFF.
5)
Close the cover and secure with the battery cover locking knobs.
Readout Battery Replacement:
Replace the Readout battery (9 volt) by removing the plastic battery compartment cover on the rear.