Stuart Turner Submersible Supersub - Manual (Page 8)

- 8 -
PIPEWORK
WARNING
Ensure pipework from pump is independently supported to prevent forces
being transferred to outlet branch.
General
All models are supplied with a 90 o elbow and stepped hose connector (see pump
connection section for details) which can be screwed directly into the pump discharge
connection.
The hose connector is suitable for a range of flexible hose sizes and can be cut to suit
the selected size. For best flow use the largest bore pipe possible minimising 90° bends.
Small pipe sizes will reduce the pump performance.
The discharge pipework must be independently supported to prevent forces being
transferred to the pump outlet branch.
ELECTRICAL INSTALLATION
WARNINGS:
 The electrical installation must be carried out in accordance with the
current national electrical regulations and installed by a competent
person.

A residual current device having a rated current not exceeding 30 mA
MUST be installed in the supply circuit. This may be part of a
consumer unit or a separate unit.
 Before starting work on the electrical installation, ensure the power
supply is isolated.
 This appliance must be earthed.

Isolate all appliances in the water from the electrical supply before
putting your hands in the water.

The power supply cord of this pump cannot be replaced. If the cord is
damaged, the pump should be scrapped.

If the pump is used to empty a swimming pool, the pump must not be
used when people are in the water.
All motors are thermally protected by an integral auto-resetting thermotrip and are rated
for continuous use.
Earthing
This appliance must be earthed via the supply cord.
Electrical Connection (Supersub & Supervort range)
The motor is provided with a factory fitted supply cord and plug. This must be connected
to the mains supply via a 13 Amp double pole switched, socket outlet in compliance with
BS 1363-2.
The socket outlet should be mounted in an easily accessible position and should be
labelled if confusion is possible, to allow easy identification of the pump isolating switch.
Cont ...