Stuart Turner Submersible Diver 35 & 45 Boostamatic - Manual (Page 6)

- 6 -
Cont ...
Starting The Pump
Turn on the electrical supply and the green L.E.D. ‘power on’ lights up. The yellow
L.E.D. lights up when the pump is running (Fig. 4).
The pump will run until the system is completely charged and the maximum pressure
reached. All taps or outlets on the system need to be operated starting with the highest
outlet. This is to release air that may be trapped in the system. If the failure (red) L.E.D.
lights up, this indicates that the pump is out of liquid or priming is incomplete. In the
event of this happening, check liquid supply to pump. If all is in order keep the RESTART
button depressed with a tap open and wait until the red failure light goes out. When the
button is released and the tap closed, the pressure control module will stop the pump at
its maximum pressure.
Do not run against a closed valve for periods longer than 5
minutes.
Power on
Pump on
Failure
Restart
STUART TURNER LTD
HENLEY-ON-THAMES
OXFORDSHIRE
RG9 2AD, ENGLAND
DISCONNECT SUPPLY BEFORE OPENING
PRESSURE
CONTROL MODULE
230V ~ 50-60 Hz, 6A max. 10bar max. Ambient 40°C max. Water Temp 65°C max.
Power on L.E.D.
(Green)
Pump running L.E.D.
(Yellow)
Failure L.E.D.
(Red)
Pressure Control
Panel
Fig. 4
Functioning
Once the commissioning operation is completed, the module will perform all pump
control operations automatically. Note: After closing any outlet there will be a small delay
time before the pump stops operating, which is normal. When particular operational
breakdowns occur, such as liquid failure, the module recognises the breakdown and the
red L.E.D. FAILURE light comes on. The pump stops operating to prevent damage caused
by its working in the absence of liquid. After rectification of the failure, the system is
restarted by depressing the restart button.
Carefully check pump and pipework for leaks whilst pump running and stationary before
leaving the installation unattended.
For Further Technical Support
Note: When pumps are installed in another manufacturers original equipment, please
contact the manufacturer for advice.
Phone the Stuart Turner Pump Assist team on 0844 98 000 97. Our staff are trained to
help and advise you over the phone or arrange for a service engineer to call.