PreSonus FaderPort - Manual (Page 18)

OPERATION
16 | P r e S o n u s 2 0 0 8
Plug-in Mode Press the “TOUCH” button to assign the fader to the plug-in devices for the currently
selected track in the main display. While in Plug-in Mode, the Left/Right arrow buttons will
allow you to scroll through the available devices. A device can then be chosen to edit by
pressing the “BANK” button. Once a device is selected the Left/Right arrow buttons allow
you to scroll through the available editable parameters for that particular plug-in. To scroll
to another device, press the “BANK” button again. To exit Plug-in Mode, press the
“TOUCH” button again.
Output Mode Press the “OUTPUT” button to assign fader control to the Master Output channel. To exit
Output Mode, press the “OUTPUT” button again.
Window Views in LIVE!
MIX Toggles between the Arrange and Session views
PROJ Toggles between the Clip and Track view
TRNS Shows/hides the Browser window
SHIFT mode functions
Session Navigation Press the “SHIFT” button to make the “WRITE”, “MIX”, “PROJ”, and
“TRNS” buttons navigation controls in the Session View window
WRITE = Up
MIX = Left
PROJ = Down
TRNS = Right
Firing clips and Scenes in LIVE! with the FaderPort in the Session view
READ Fires the currently selected Clip or Stops a playing clip from the same track if the
current clip slot is empty
TOUCH Fires the currently selected scene and will advance the scene selection to the next
scene below.
Firing Clips and Scenes with a Footswitch
While is the Session View, the currently selected scene can be fired by pressing the footswitch. The scene
selection will advance to the next scene below. To fire a selected clip, enable Shift mode by pressing the
“SHIFT” button. The footswitch will now fire selected clip. Once the selected track is record enabled, the
footswitch will begin recording a clip if pressed once, pressing it again will stop the recording.