NcSTAR VDFLGQ142 User Manual
Page 7
ZEROING YOUR LASER SIGHT
ADJUSTING WINDAGE AND ELEVATION:
The integrated Green Laser Sight on your VDFLG142 is adjustable for both Windage and Elevation. The
Green Laser Windage Adjuster (Left side) and Elevation Adjuster (Top side) are both found on the front of
the Green Laser Housing, and can be adjusted using the provided Allen wrench.
To adjust the Elevation Up, turn the Laser Elevation Adjuster Counter-Clockwise, and to adjust the
Elevation Down turn it Clockwise.
To adjust the Windage Left, turn the Laser Windage Adjuster Counter-Clockwise, and to adjust the
Windage Right turn it Clockwise.
NOTE: For sighting in your Laser Sight, please use the instructions above titled SIGHTING IN YOUR
RED DOT SIGHT.
BATTERY INSTALLATION
Your Red Dot Optic comes ready to use with a pre-installed battery. If the battery life expires or your Red
Dot reticle no longer illuminates, follow these simple instructions:
1. The Battery compartment is located within the Rheostat Knob.
2. On the top of the Rheostat Knob you will notice a thin Battery Cap. To remove this cap, grasp it
firmly with one hand and twist it counter-clockwise while holding the Rheostat Knob firmly in place
with the other hand.
3. Remove the old battery and dispose of it properly. Replace it with a new 3 volt
Lithium Battery type CR2032 only. Place the Battery in the Battery compartment with the
Positive “+” terminal facing out. Twist the Battery Cap back on to the Rheostat Knob and hand
tighten. Avoid using tools (such as pliers) to perform this procedure as this may cause damage to
the unit.
The Green Laser and the Flashlight each use a 3 Volt Lithium CR123A Battery. At the rear of each unit,
you will find a push button On/Off Switch Cap. Turn the Switch Cap Counter-Clockwise to remove it from
their respectable bodies.
The Green Laser Switch Cap will not have a spring at the end of the Switch, it will be smooth. The
CR123A battery is inserted into the Green Laser Body with the Positive Terminal “+” facing Out.
The Flashlight Switch Cap will have a spring at the end of the Switch. The CR123A battery is
inserted into the Flashlight Body with the Positive Terminal “+” going In. The Negative Terminal
“-“ facing out.
Turn the Switch Caps in Clockwise into each of their respectable bodies until the Cap switch is flush with
the Body.