NcSTAR AQPTFLG - Manual (Page 2)

INSTALLING THE BATTERY:
Before you mount and use your Green Laser/ LED Flashlight [FIGURE 1] you must first install the CR123A battery
(included). This is a very simple procedure that takes only a few moments. Begin by grasping the Main Body and
remove the Green Laser or LED flashlight front assembly from the Main Body, by turning the front assembly
counter clockwise until the front assembly is separated from the main body. This will reveal the battery
compartment, remove the old battery if there is one present, insert a new CR123A battery into the battery
housing with the positive “+” terminal of the battery facing out. Finish the battery installation by re-attaching the
front assembly of your choice (Green Laser or LED Flashlight), by turning the front assembly clockwise until it is
firmly snug against the main body. When it is time to replace the battery, only use type CR123A Lithium.
MOUNTING THE LASER OR FLASHLIGHT ONTO THE FIREARM:
 CAUTION: BEFORE YOU MOUNT OR REMOVE THE GREEN LASER/ LED
FLASHLIGHT FROM YOUR FIREARM, BE SURE THAT THE FIREARM IS
UNLOADED AND IT IS POINTED INTO A SAFE DIRECTION! ALWAYS
PRACTICE SAFE FIREARMS HANDLING PROCEDURES.
To mount your Green Laser or LED Flashlight onto your Weaver/Picatinny style rail, grasp the unit by the Main
Body and position the unit in front of the rail so the Laser or Flashlight bezel is facing in the same direction as the
muzzle of the firearm. Depress the Quick Release Lever and slide the Tactical Laser/ Flashlight straight back and
align the recoil stud on the Quick Release mount with one of the recoil groove(s) on the rail of the firearm, until
the unit locks into place. Your Tactical Laser or Flashlight is now securely mounted to your firearm.
REMOVING THE LASER/ FLASHLIGHT FROM YOUR FIREARM:
To dismount the Tactical Laser or Flashlight, grasp the Main Body and depress the Quick Release Lever. Slide the
unit forward until it has cleared the rail on the firearm completely. Your Tactical Laser or LED Flashlight is now
dismounted.
 WARNING: The Tactical Laser will securely mount onto most
Weaver/Picatinny rails, but not all (depending on the location of the cross-
slots on the rail itself).
LASER/ FLASHLIGHT ON/OFF SWITCH OPERATION:
Once you have your Tactical Laser mounted, it is very quick and convenient to turn it the unit on and off. On the
rear of the Main Body you will notice the Sliding ON/OFF Switch. To turn the unit on, simply push the right side of
the slide switch over to the left until you feel it click into place. To turn the unit off, push the slide switch in the
opposite direction until it clicks into place. If the unit will not illuminate, check to make sure that the battery is
installed in the proper direction. To conserve the life of the battery, be sure that the unit is in the off position
when not in use. If you plan on storing the unit for a long period of time it is best to remove the battery and set
it aside.