NcSTAR ARLSG User Manual

Page 3

Advertising
background image

INSTALLING THE BATTERY:

Your new Green Laser uses one 3 volt lithium battery which is type CR123A. Always use
this type of battery for best performance results, and to avoid damage to the laser. To
install the battery, simply remove the Rear Cap Switch(4) by turning it counter
clockwise. Next, place the battery into the Battery Housing(14)with the positive side
facing out towards the Rear Cap Switch(4). Twist the Rear Cap Switch(4) back onto the
rear of the laser. To use the Coil Pressure Switch(10), remove the standard On/Off Cap
Switch(4) by turning it counter clockwise. Remove the Spring Insert(12) from the
Threaded Coupling(13) portion of the switch by gently pushing it out. String the Pressure
Pad side(10) of the coil through the inside part of the Threaded Coupling(13). Pull the
pad all the way through until the Battery Connection(8) portion of the coil becomes
flush with the Threaded Coupling(13). Now twist the Threaded Coupling(13) onto the
rear of the laser until it is tight. If this procedure was done correctly, you should see the
laser beam appear every time the Pressure Pad(10) is depressed. Always be sure that
the unit is off when not in use to preserve battery life.

™

If you are not sure about any of the procedures in this manual,
always seek the help of a qualified professional to avoid
damage to your Green Laser and your firearm.

SPECIFICATIONS:

Wavelength: 532 nm

Output Power: 5mW

Operating Voltage: 3V DC

Battery type: one CR123A lithium

Line Width: <0.1 nm

Beam Divergence: <1mrad

Beam diameter: < 1 mm

Operation Current: <300mA

Operating temperature: 59 - 95 degrees Fahrenheit

SPECIAL NOTE: THIS UNIT WILL ONLY FUNCTION UNDER THE TEMPERATURES LISTED ABOVE.
THE UNIT WILL NOT FUNCTION IN EXTREME COLD OR EXTREME HEAT. ONCE THE UNIT HAS
RETURNED TO NORMAL TEMPERATURES IT WILL FUNCTION PROPERLY.

Advertising