Actiontec electronic DataLink V.90 PC Card Fax Modem PCMCIA - Manual (Page 23)

20
4 Installing the Driver Software
21
DataLink V.90 PCMCIA Fax Modem
6. When the final “Add New Hardware Wizard” window appears, click Finish.
The driver software is loaded. Next, go to chapter 5, “Installing the
Communications Software.”
Windows NT 4.0
Before beginning this installation, ensure that the COM 2 port has been disabled
in the system BIOS, and that the PCMCIA is set to “boot” and “started” as
described in chapter 2, “Before You Begin.”
To load the Modem’s software drivers onto a computer running Windows NT 4.0:
1. Insert the Modem into the computer’s PCMCIA slot.
2. Turn on the computer.
3. After the computer boots up, select Start, Settings, Control Panel,
then Modems.