ReadyLIFT Dodge Ram 3500, 2003-2013, 4WD Only 3.0F/2.0"R SST Lift Kit" User Manual
Page 6
NOTE: If you experience any difficulty attempt-
ing to install the OE springs, disconnect the
steering rod that connects the pitman arm on
the steering box to the relay rod which extends
from tie rod to tie rod at the pitman arm. This
will allow the suspension to extend down more.
Once the vehicle reaches the ground reconnect
the steering rod and torque to spec.
Once the front springs are both installed, lower
the vehicle and reconnect the lower shock bolts
and tighten the upper shock mounting brackets.
Reconnect lower sway bar end links. Recheck
all work performed. Reinstall wheels/tires, low-
er to ground and torque.
www.ReadyLIFT.com
Phone (702)410-2300
Installation Instructions 69-1091 & 69-1092
Rear Block Instructions
Raise rear of vehicle on level ground and support frame.
Support axle and disconnect lower shock mounting hardware.
Disconnect U-bolts and remove, one side of vehicle at a time.
Slowly lower rear axle.
Place new lift block on axle pad, center pin down.
Carefully raise axle and align centering pin.
Note -1 inch Block pictured
below