ReadyLIFT Dodge Ram 3500, 2003-2013, 4WD Only 3.0F/2.0"R SST Lift Kit" User Manual
Page 7
Advertising
Note : If installing 2 inch lift block the large
end of the taper must be installed towards
rear of vehicle. Short side will be facing front
of vehicle.
Next, lower vehicle to the ground and torque
the u-bolts with the weight on the axle. Re-
check all work and tighten all hardware to
factory spec., then test drive.
www.ReadyLIFT.com
Phone (702)410-2300
Installation Instructions 69-1091 & 69-1092
Install new u-bolts and hardware, reattach shock and tighten.
Advertising
This manual is related to the following products: