Readylift – ReadyLIFT Ford F250 Super Duty SST Lift Kit: 1999-2004, 4WD Only - 2.0F/2.0"R" User Manual

Page 5

Advertising
background image

ReadyLift

®

(Part# 69-2085)

1999-2004 Ford F-250 4WD Lift Kit

Installation Instructions

Revised

6/3/2010

ReadyLift Suspension, Inc.

3201 W. MacArthur Blvd, Santa Ana, CA, 92704

Tol l Fre e (8 8 8 )9 2 2 - 2 2 9 4 F ax 7 1 4 - 86 2 - 2 9 72

Please read instructions thoroughly and completely before beginning installation.

Check www.Readylift.com for any updated installation instruction.

Installation by a trained mechanic is recommended.

Using a jack and block of wood, carefully raise the truck by the

leaf spring until OEM block is loose and there is enough room
the for new block. Install the ReadyLift® 4” rear block.

Please make note that the arrow on the top of the block
points to the front of the truck.

Lower the jack and make sure that the leaf spring

center pins goes into the hole on the top of the block

and the center pin on the block go into the axle pad. Install
ReadyLift® u-bolts and the nuts provided in the kit. Tighten to

148ft-lbs. CHECK ALL HARDWARE FOR TIGHTNESS AF-
TER FIRST 100 MILES AND AFTER OFF ROAD USE.

HEADLIGHTS SHOULD BE ADJUSTED.

19.

Install the .460 hex cam on the front side of the track bar

bracket and the .390 hex cam on the back side. Install the
9/16-18x4” bolt, washers and nut.

Tighten the track bar mounting bolts to 105 ft-lb.

17.

18.

Rotate the sleeves so that the holes as far away from each

other as possible.

Install the .230 offset hex cams into the track bar bracket on

the axle. Install the 9/16-18x3.5” bolt washers and nut. DO
NOT TIGHTEN.

15.

16.

Advertising