ReadyLIFT Toyota Tundra SST Lift Kit: 2007-2012, 2WD & 4WD - Non-TRD - 3.0F/1.0"R" User Manual
Page 4
www.ReadyLIFT.com
Phone (702)410-2300
Installation Instructions (69-5075 & 69-5076)
Attach strut extension spacer with OE mounting hardware
Reattach upper strut mount with provided nuts and tighten
Reattach and tighten lower strut mounting hardware
Raise lower control arm, reattach
(2)
ball joint mounting bolts
Reinstall wheels/tires, lower vehicle, reattach sway bar ends
Install (2) skid plate spacers with new hardware
T6-5075 spacer shown
**Tighten lower control arm bolts
check all work,
test drive and have vehicle aligned
4WD models only
: Remove front skid plate from
vehicle. Next, place a jack/support under front differ-
ential. Remove the (2) front differential mounting
bolts. Lower the differential enough to allow installa-
tion of the (2) 1” spacers between the frame and the
mounts. Install the provided longer bolts and nuts w/
the OE washers. Torque to factory spec. Then rein-
stall the factory skid plate with the provided 1/2” tall
spacers and longer bolts in the front mounting loca-
tions. See photos below.
Install (2) differential spacers and tighten to spec