ReadyLIFT Toyota Tundra 4 SST Lift Kit: 2007-2014, 2WD/4WD - 4.0"F-2.0R"" User Manual
Page 5
Note: Take extra precaution in the removal and
installation of the factory upper control arm
bolts, they are extremely long and there are
electrical components and hoses in the way of
this process. On the passenger side, front air
bag sensor wiring is in close proximity to the
fender well. You may also wish to unclip the
coolant lines near the pass. fender well. Make
sure to reattach any components removed in
these steps upon completion of the upper con-
trol arm installation.
www.ReadyLIFT.com
Phone (702)410-2300
Installation Instructions (69-5475 & 69-5476)
Remove upper control arm.
Loosen and remove lower strut mounting hardware.
Remove upper strut mounting nuts and remove entire unit.
It may be necessary to loosen lower control arm cams bolts.
Remove OE compression stops above lower control arms
Install provided spacers in front and rear locations.
Reinstall OE compression stops on to provided spacers.
4WD only. Remove (2) front differential mounting bolts.