ReadyLIFT Honda Pilot, 2009-2011, 2WD & 4WD, 2.0F/1.0"R" User Manual
Page 2

ReadyLift
®
(Part# 69-8010)
Honda Pilot FWD/4WD Installation Instructions
Revised
7-26-10
ReadyLift Suspension, Inc.
3201 W. MacArthur Blvd, Santa Ana, CA, 92704
Tol l Fre e (8 8 8 )9 2 2 - 2 2 9 4 F ax 7 1 4 - 86 2 - 2 9 72
Please read instructions thoroughly and completely before beginning installation.
Check www.Readylift.com for any installation instruction updates
Installation by a trained mechanic is recommended.
Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground.
Use a minimum 3 ton jack stands and place under frame for safety or a (2) two post lift if available.
Make sure that the emergency brake is on and the rear wheels are blocked to prevent a rollout.
1.
3.
4.
2.
Open the hood and set at highest setting. Remove the
front wheels. Starting on the driver side.
Use a flat screwdriver to remove windshield wiper ac-
cess panel . Remove the three 14mm upper strut nuts.
Remove the brake line support bracket using a 12mm
wrench.
Use a 10mm wrench and remove the ABS line support
bracket bolt.
Bill of Materials
Description Qty
Driver side strut extension, front
Passenger side strut extension, front
Sway bar end link, front
M10 x 1.25 flange nut
1” coil spacer, rear
Shock extension, rear
Adjustable camber arm, rear (67590)
1
1
2
10
2
2
2