ReadyLIFT Honda Pilot, 2009-2011, 2WD & 4WD, 2.0F/1.0"R" - Manual (Page 3)

ReadyLift
®
(Part# 69-8010)
Honda Pilot FWD/4WD Installation Instructions
Revised
7-26-10
ReadyLift Suspension, Inc.
3201 W. MacArthur Blvd, Santa Ana, CA, 92704
Tol l Fre e (8 8 8 )9 2 2 - 2 2 9 4 F ax 7 1 4 - 86 2 - 2 9 72
Please read instructions thoroughly and completely before beginning installation.
Check www.Readylift.com for any installation instruction updates
Installation by a trained mechanic is recommended.
5. 6.
Unbolt and remove the front sway bar end link. You will
not reuse this part.
A 24mm wrench and socket will be needed to remove
the lower strut mounting bolts.
7. 8.
Carefully remove the strut from the vehicle making sure
not to drop it on the outer CV boot. Tilting the knuckle
towards the rear of the vehicle will make removal easier.
Please note that the ReadyLift strut extensions are
driver side and passenger side specific. Arrow points
toward front of vehicle
9. 10.
Install the Readylift strut extension using the OEM hard-
ware. Tighten to nuts to 30 lb-ft.
Install strut back into factory location, install nuts sup-
plied with kit but leave loose.
Remove sway bar end link
D P