ReadyLIFT Ford Raptor 2010-2014 - Mid Travel Off Road Upgrade Kit User Manual
Page 8
www.ReadyLIFT.com - Phone: (800) 549-4620
Installation Instructions 44-2150
8
Add a small amount of lubricant such as grease to the o-ring on the cap
to help seat the cap. To seat cap you may need to tap with rubber mallet.
37.
Torque everything down to factory specifications and recheck the installation
to ensure it was done properly. Put the tires on the
vehicle and set it on the ground. The
vehicle must be aligned prior to
driving .
38.
Final Checks & Adjustments
Post Installation Warnings: Once the vehicle is lowered to the ground, check all parts which have
rubber or urethane components to insure proper torque. Torque wheels to factory specs. Move vehicle
backwards and forwards a short distance to allow suspension components to adjust. Turn the front
wheels completely left then right and verify adequate tire, wheel, brake line, and ABS wire clearance.
Test and inspect steering, brake and suspension components for tightness and proper operation. In-
spect brakes hoses and ABS lines for adequate slack at full extension. Failure to perform the post in-
spection checks may result in vehicle component damage and/or personal injury or death to driver and/
or passengers. Test drive vehicle and re-check the torque of all fasteners and re-torque wheels on ve-
hicle. Re-adjust headlamps.
Vehicle Handling Warning: Vehicles with larger tires and wheels will handle differently than stock
vehicles. Take time to familiarize yourself with the handling of your vehicle
.
Wheel Alignment/Headlamp Adjustment:
It is necessary to have a proper and professional wheel alignment performed by a certified
alignment technician. Align the vehicle to factory specifications. It is recommended that
your vehicle alignment be checked after any off-road driving. In addition to your vehicle
alignment, for your safety and others, it is necessary to check and adjust your vehicle
headlamps for proper aim and alignment
Vehicle Re-Torque and Safety Inspection:
Upon completion of all services and adjustments performed on your vehicle, and within 50 miles of driv-
ing, check to ensure all fasteners and hardware are properly torqued to specification as noted in the
vehicles factory service manual or the torque chart included.