STI UB-1PN - Manual (Page 2)

- 2 -
NOTES
It is important to read, understand and follow all instructions provided with this
product. It is the installer’s responsibility to comply with NFPA 70 & 101, NEC,
mounting specifications according to ADA and other applicable electrical
codes. To avoid electrical shock, DO NOT attempt to install this product when
power is on. ADA mounting compliance requires the operable part of the
initiating device shall not be less than 3 1/2 ft. (1.1m ) or greater than 4 1/2 ft.
(1.37m) above finished floor surface. After installation and testing are complete,
provide a copy of this manual to all personnel responsible for testing and
maintenance of this product.
* For access control installations, power for the UB-1PN must be supplied by a
power source Listed to UL294. When used for access control, this device shall
be used as a part of an access controlled egress door system. It is up to the
local AHJ to allow use of this device in place of an automatic sensor. For higher
security installations, lower time limits should be used.
SWITCH RATING Independent Form “Z” contacts
Rated at: 10A @ 240 VAC
Operating Temp: 15° to 120°F (-9° to 49°C)
1,000,000 Cycles
4.83 in.
(123mm)
3.22 in.
(82mm)
.91 in.
(23mm)
1.47 in.
(38mm)