STI UB-1PN - Manual (Page 3)

- 3 -
1. Choose button message and color. If same as existing, proceed to
2. If choosing a new message, remove button. On the back side of the plate,
squeeze tabs and push actuator assembly into plate just enough to grasp the
button and remove.
3. From the front of the plate, push actuator back into original position.
4. Choose button message. Blank plate is available for your custom message.
a. Insert button message, align 4 notches on actuator.
b. Select color lens. Align top and bottom notches with tabs on
actuator and push until it snaps together.
TO CHANGE BUTTON COLOR AND ROUND MESSAGE
CHANGE TOP MESSAGE
1. Remove LED circuit board.
2. Remove current message by pushing in and
down on tabs 1 and 2 with a small
screwdriver. If necessary, also push in and
down on tabs 3 and 4. Once message is loose,
remove from the front of the plate.
3. Select new message and snap into place.
Blank plates are included to create your own
custom message.
DIFFUSER
BUT
BUT
BUT
1
2
3 4
SCREWDRIVER
1
BUT
BUTTON ACTIVATED
M
UB-1L LED PCB
NYLON WASHER
SCREW
1
2
2
SQUEEZE TABS
AND PUSH
ASSEMBLY
INTO PLATE
POWER IN
12-30 VDC/VAC