STI 9745 - Manual

Safety Technology International, Inc.
2306 Airport Road • Waterford, Michigan 48327-1209
Phone: 248-673-9898 • Fax: 248-673-1246
Toll Free: 800-888-4784 • E-mail: [email protected]
Web: www.sti-usa.com
Safety Technology International (Europe) Ltd.
Unit 49G Pipers Road • Park Farm Industrial Estate • Redditch
Worcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999
Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only)
E-mail: [email protected] • Web: www.sti-europe.com
INSTALLATION OF STI-9745 LOW VOLTAGE SPLICE BOX
All specifications and information shown were current as of publication, and are subject to change without notice.
9745 MAY2006
OUTLET TUNNEL
INLET TUNNEL
INLET TUNNEL
1
SELECT THE INLET TUNNEL TO BE USED,
AND CAREFULLY CUT A SECTION OF
THE TUNNEL WALL TO BE USED FOR
WIRE ACCESS.
R
STUD EDGE
NAILING FLANGE
2
OUTLET TUNNEL
TYPICAL WOOD
OR STEEL STUD
TOP VIEW RECOMMENDED (4) FASTENERS
4D NAIL OR DRYWALL SCREW
(NOT PROVIDED)
ROUTE WIRES UP STUD LENGTH TO SELECTED HEIGHT. COIL AND SECURE WIRES AS SHOWN.
PLACE THE LOW VOLTAGE OUTLET HOUSING OVER COILED WIRES. MAKE SURE OUTLET
TUNNEL IS BUTTED AGAINST STUD EDGE AND NO WIRES ARE PINCHED BETWEEN STUD AND
NAILING FLANGE. SECURE HOUSING WITH EITHER SCREWS OR NAILS.
L
NOTE: MUST INSERT SCREWS/NAILS ON BOTH SIDES OF
THE OUTLET TUNNEL TO BE SURE DRYWALL BULGES IF
HOLES ARE NOT CUT BY DRYWALL INSTALLER
TYPICAL WOOD
OR STEEL STUD
3
LEAVE APPROXIMATELY 1 INCH OF
WIRE EXPOSED AS SHOWN
I
INLET TUNNEL
INLET TUNNEL
INLET TUNNEL
3 1/2 in.
(89mm)
1 13/16 in.
(46mm)
1 1/8 in.
(29mm)
3/8 in.
(10mm)
9/16 in.
(14mm)
2 7/8 in.
(73mm)
N
PRODUCT DIMENSIONS
DRY WALL
OR SHEETING
TYPICAL WOOD
OR STEEL STUD
TOP VIEW
1
4
Electronic warranty form at www.sti-usa.com/wc14