Anthro Utility Bench II Assembly Instructions - Manual (Page 4)

4 Questions? Call us at 800.325.3841 or visit anthro.com. We’re happy to walk you through the assembly!
STEP 3
Add the Cross Tubes
NOTE: This is a 2-person step. One person holds the
Cross Tubes while the other drives the Cap Screws.
¡ Position the Right Leg Assembly (from Step 2) with
two Cross Tubes as shown. Insert one Bench Cap Screw
with a Curved Washer through a side hole, carefully
threading the Screw into the Cross Tube.
¡ Repeat for the remaining three side holes.
STEP 4
Determine the Shelf Height
¡ These instructions will place the Shelf at 35" above
the floor (with the 5" casters). The holes along the Leg
Assemblies are spaced at 1" increments. Adjusting one
hole down on the Leg Assembly will make the Shelf
34" above the floor.
NOTE: The Shelf height can be adjusted later if
needed; steps 5-8 will need to be disassembled
and reassembled again.
Bench Cap Screw
325-5166-00
Curved Washer
225-3522-00
35"
Cross Tubes