Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 107)

Output from the show ip pim all-vrf hw-resource command TABLE 3
Field Description
VRF Name of the VRF.
Usage Number of allocated SG entries in this VRF.
Fail Number of failures while allocating SG entries in this VRF (due to the system-max
limit.
Total usage Total number of SG entries in the system (all VRFs).
System-max limit for SG entries Configured system limit for pim-hw-mcache.
Displaying PIM Sparse configuration information and statistics
You can display the following PIM Sparse information:
• Basic PIM Sparse configuration information
• Group information
• BSR information
• Candidate RP information
• RP-to-group mappings
• RP information for a PIM Sparse group
• RP set list
• PIM neighbor information
• The PIM flow cache
• The PIM multicast cache
• PIM traffic statistics
• PIM counter statistics
Displaying basic PIM Sparse configuration information
To display PIM Sparse configuration information, enter the following command at any CLI level.
Device(config)# show ip pim sparse
Global PIM Sparse Mode Settings
Maximum Mcache : 12992 Current Count : 2
Hello interval : 30 Neighbor timeout : 105
Join/Prune interval : 60 Inactivity interval : 180
Hardware Drop Enabled : Yes Prune Wait Interval : 3
Bootstrap Msg interval : 60 Candidate-RP Msg interval : 60
Register Suppress Time : 60 Register Probe Time : 10
Register Stop Delay : 10 Register Suppress interval : 60
SSM Enabled : Yes SPT Threshold : 1
SSM Group Range : 232.0.0.0/8
Route Precedence : mc-non-default mc-default uc-non-default uc-default
Syntax: show ip pim [vrf vrf-name ] sparse
Displaying PIM Sparse configuration information and statistics
FastIron Ethernet Switch IP Multicast Configuration Guide 105
53-1003085-02