Brocade ICX 7750 Hardware Installation Guide User Manual
Page 26
16
Brocade ICX 7750 Hardware Installation Guide
53-1003084-01
2
Installing the device in a rack or cabinet
•
Eight 8-32 x 5/16 in., panhead Phillips screws.
2. Attach the mounting brackets to the sides of the device as illustrated in
using the
8-32 x 5/16 in. screws.
FIGURE 11
Attaching the mounting brackets for a Brocade ICX 7750
3. Position the device in the cabinet, providing temporary support under the switch until the rail
kit is secured to the cabinet.
4. Attach the front right bracket to the rail rack using two 10-32 x 5/8 in. screws and the
appropriate round-hole or square-hole retainer nuts.
5. Repeat
to attach the left front bracket to the left front rack rail and tighten all 10-32 x
5/8 in. screws to a torque of 25 in-lb (29 cm-kg). Refer to
FIGURE 12
Installing the Brocade ICX 7750 in a 2-post rack
Proceed to