Brocade ICX 7750 Hardware Installation Guide - Manual (Page 7)

Brocade ICX 7750 Hardware Installation Guide vii
53-1003084-01
About This Guide
The Brocade ICX 7750 are Ethernet switches for campus LAN aggregation and classic Ethernet
data center Top-of-Rack (ToR) environments.
Audience
This document is designed for system administrators with a working knowledge of Layer 2 and
Layer 3 switching and routing.
If you are using a Brocade Layer 3 Switch, you should be familiar with the following protocols if
applicable to your network: IP, RIP, OSPF, BGP, ISIS, PIM, and VRRP.
Supported hardware and software
This document is specific to the Brocade ICX 7750 running FastIron release 08.0.10.
How this document is organized
The document contains the following components:
• Chapter 1, “Brocade ICX 7750 Overview” provides an overview of the Brocade ICX 7750.
• Chapter 2, “Installing the Brocade ICX 7750” provides the information needed to install the
switch in your network.
• Chapter 3, “Brocade ICX 7750 Operation” discusses the day-to-day operational procedures for
using the switch.
• Chapter 4, “Managing the Brocade ICX 7750” provides procedures for removing and replacing
the field-replaceable units (FRUs), including the fan assemblies and power supplies.
• Appendix A, “Brocade ICX 7750 Specifications” provides tables of physical, environmental, and
general specifications.
• Appendix B, “Brocade ICX 7750 Regulatory Statements” provides a list of the regulatory
statements for safety compliance.
• Appendix C, “Brocade ICX 7750 Cautions and Danger Notices” provides a list of the
international caution and danger statements for safety compliance.