Adding or deleting protected vlans, Setting the system maximum, Displaying openflow configuration information – Brocade Multi-Service IronWare Software Defined Networking (SDN) Configuration Guide (Supporting R05.6.00) User Manual
Page 21
Multi-Service IronWare SDN Configuration Guide
11
53-1003034-02
Hybrid switch and OpenFlow hybrid port mode
1
Adding or Deleting protected VLANs
Use openflow protected -vlans to add or delete protected VLANs on a hybrid port-mode interface.
The no form of the command deletes the configured protected VLANs from the hybrid-enabled port.
Brocade(config-if-e10000-2/5)# openflow protected-vlans 10
Syntax: [no] openflow protected-vlans id1 id2 …idn
VLANs can be configured individually.
NOTE
A VLAN range is not specified for this command .
Setting the system maximum
The system-max openflow-pvlan-entries command sets the CAM size of OpenFlow protected VLAN
entries for the device. By default, this value is set to 0.
Brocade(config)# system-max openflow-pvlan-entries 2000
Syntax: system-max openflow-pvlan-entries value
The value variable represents the number of port and protected VLAN combination entries that can
be configured in the system. The range is from 0 to 2048. after using this command, you must
reload the system.
The system-max openflow-unprotectedvlan-entries command sets the CAM size of OpenFlow
unprotected VLAN entries for the device. By default, this value is set to 0.
Brocade(config)# system-max openflow-unprotectedvlan-entries 1000
Syntax: system-max openflow-unprotectedvlan-entries value
The value variable represents the number of port and unprotected VLAN combination entries that
can be configured in the system. The range is from 0 to 2048. after using this command, you must
reload the system.
Displaying OpenFlow configuration information
The show OpenFlow command displays the configuration for OpenFlow.
Brocade(config)# show openflow
Number of Controllers: 2
Controller 1:
Connection Mode: passive, TCP,
Listening Address: 0.0.0.0
Connection Port: 6633
Connection Status:
SSL Connection :False
No TCP connection found.
Controller 2:
Connection Mode: active, TCP,
Controller Address: 10.20.101.199
Connection Port: 23
Connection Status: