Brocade TurboIron 24X Series Hardware Installation Guide - Manual (Page 53)

Brocade TurboIron 24X Series Hardware Installation Guide 43
53-1002981-01
Replacing a power supply
5
Installing an AC power supply
NOTE
If the empty power supply bay has a cover plate, remove it as shown below before continuing.
FIGURE 17 Releasing the cover plate
FIGURE 18 Removing the cover plate
1. Remove the new power supply from its packaging.
2. Hold the bar on the front panel of the power supply with one hand and ensure that the cotter
pin on the right side of the power supply is correctly aligned. With the other hand, support the
underside of the power supply, and insert the power supply into the empty power supply slot.
3. Push inward until the supply is completely in the slot, so that the connectors on the back of the
supply fully engage with the pins on the power backplane.
DANGER
Make sure you insert the power supply right-side up. It is possible to insert the supply upside
down, although the supply will not engage with the power backplane when upside down. The
power supply is right-side up when the power connector is on the left and the fan vent is on the
right.