Brocade TurboIron 24X Series Hardware Installation Guide - Manual (Page 55)

Brocade TurboIron 24X Series Hardware Installation Guide 45
53-1002981-01
Replacing the fan tray
5
FIGURE 21 Connecting the power cord
6. Power on the supply and verify that it is working properly as instructed in “Powering on the
system” on page 18 and “Verifying proper operation” on page 19.
Replacing the fan tray
You can replace the fan tray while the TurboIron 24X is powered on and running. The fan tray is
located in a slot at the rear of the TurboIron 24X.
This section provides information about the following topics:
• Installation precautions and warnings
• Replacing the fan tray
Installation precautions and warnings
Follow these precautions when removing and installing a fan tray in the TurboIron 24X.
CAUTION
Be careful not to accidently insert your fingers into the fan tray while removing it from the chassis.
The fan may still be spinning at a high speed.
CAUTION
Do not install the device in an environment where the operating ambient temperature might
exceed 40°C (104°F).