Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 54)

DANGER
If the installation requires a different power cord than the one supplied with the device, make
sure you use a power cord displaying the mark of the safety agency that defines the
regulations for power cords in your country. The mark is your assurance that the power cord
can be used safely with the device.
Installation precautions
Follow these precautions when installing the chassis.
General precautions
DANGER
All fiber-optic interfaces use Class 1 Lasers.
CAUTION
Do not install the device in an environment where the operating ambient temperature can
exceed 40 ° C (104 ° F).
CAUTION
Make sure the air flow around the front, sides, and back of the device is not restricted.
CAUTION
If you do not install a module in a slot, you must keep the slot panel in place. If you run the
chassis with an uncovered slot, the system will overheat.
CAUTION
Never leave tools inside the chassis.
Lifting precautions
DANGER
A fully populated chassis is heavy. TWO OR MORE PEOPLE ARE REQUIRED WHEN LIFTING,
HANDLING, OR MOUNTING THESE DEVICES.
Installation precautions
52 Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1003092-01