Brocade Mobility RFS9510 Controller Installation Guide - Manual (Page 6)

2 Brocade Mobility RFS9510 Controller Installation Guide
53-1002918-01
Site preparation
1
• Do not install this equipment or work with its power circuits during thunderstorms or other
weather conditions that could cause a power surge.
• Verify there is adequate ventilation around the device, and ambient temperatures meet
equipment operation specifications.
Site preparation
• Consult your site survey and network analysis reports to determine specific equipment
placement, power drops, and so on.
• Assign installation responsibility to the appropriate personnel.
• Identify and document where all installed components are located.
• Provide a sufficient number of power drops for your equipment.
• Ensure adequate, dust-free ventilation to all installed equipment.
• Identify and prepare Ethernet and console port connections.
• Verify cable lengths are within the maximum allowable distances for optimal signal
transmission.
Getting started
This guide provides a pre-installation checklist and instructions for installing the Mobility RFS9510
Controller, accessing the Graphical User Interface (GUI), and performing initial configuration.
Pre-installation checklist
Location & equipment
Mobility RFS9510 Controller shipping container contents:
• Mobility RFS9510 Controller
• Locking front bezel with keys
• Mounting rail kit
• Brocade Mobility RFS9510 Controller Installation Guide (this document)
NOTE
Keep the front bezel keys in a secure location which can only be accessed by authorized personnel.
Additional equipment recommended
• Standard, grounded 100-240 VAC 50/60 Hz connection
• UPS (uninterruptable power supply)
• Standard 19-inch rack (2U height) with mounting rails.