Davey SP1200-60 (1ph) SPAPOWER CONTROLLER - Manual (Page 9)

Page 26
8. ADV. OPTIONS
- - - -
(SUBMENU) ( ) ( )
(ESC) ( ) ( )
- - - -
ADV OPTIONS
Push 8
1. HEAT CONTROL
2. HIGH HT OFFS
3. FILT. PERIOD*
4. FILT. TIME*
(SET) ( ) ( )
O.50
1. HEAT CONTROL
Scroll to SET
1. SET TEMP
2. USER TIMER
3. CLOCK
4. USER ALARM
5. SLEEP TIMES
6. MAINT TIMERS
7. MISC OPTIONS
9. LD. DEFAULTS
8. ADV. OPTIONS
*N/A circulation pump installations
Select MAIN menu then push UP button 8 times
7.8.7 Panel And Pool Light Synchronisation (on/off)
The SP1200 touch pad backlight has the ability to mirror the colour and intensity of the in-pool Spa Power Variable
Colour Light (SPVCL). This feature is most noticeable when a light effect mode is being used and the light colour is
changing rapidly.
When the pool light is turned off the touch pad backlight will remain one user selectable fixed colour. If desired the
synchronising/mirroring feature can be disabled and the touch pad backlight will remain on the fixed colour even
when the pool light is turned on.
7.8.8 Enabling/Disabling Light Synchronisation
7.9 Advanced Options Submenu
The advanced options menu contains settings that should only be modified after you are familiar with the basic
operation of the spa. The defaults will generally be satisfactory and will probably not need to be changed.
1) Select the MISC OPTIONS submenu from the main menu.
2) Select the PANEL & POOL LT. SYNC menu item
3) Press the SCROLL button modify light synchronisation setting
4) Use the UP and DOWN buttons to toggle between on and off
5) Press the SCROLL button to set.
Note: This option is only available if a SPVCL (Spa Power Variable Colour Light) is in the pool.
Page 7
3.3 Pump 1
(Two speed, 24HR circulation pump fitted)
This pump is controlled via two touch pad buttons - one to turn the pump on/off and another to change its speed.
The mode and pump speed selected by these buttons are shown for a few seconds on the LCD display as well as
being indicated by the pump button LEDs. The two pump button LEDs are green, red or off when the pump is on-
low, on-high or off.
Two pushes of the on/off button cycles the pump as follows:
Two pushes of the on/off button cycles the pump as follows:
Notes:
1) If left on, these pumps will automatically switch off after 25 minutes.
2) If the heater element is on, running either pump in high speed mode may cause the heater to load shed and
switch off. If this occurs the heater will come back on approximately 5 seconds after high speed is deselected
(pump running in low speed or pump off).
Pump 1
Pump 2
Push 1 (Pump On)
Push 2 (Pump Off)
LCD displays “PUMP OFF”, button LEDs off. The Hi/Low speed button has no effect in this mode.
Push 1 (Pump Hi)
Push 2 (Pump Low)
The Hi/Low speed button can be used to change the pump speed:
Push 1 (Pump On)
Push 2 (Pump Off)
LCD displays “PUMP OFF”, button LEDs off. The Hi/Low speed button has no effect in this mode.
Push 1 (Pump Hi)
Push 2 (Pump Low)
The Hi/Low speed button can be used to change the pump speed: