Elitegroup P60 - Manual (Page 4)

ii
Notices
F EDERAL C OMMUNICATIONS C OMMISSION R ADIO F REQUENCY
I NTERFERENCE S TATEMENT
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and if not installed and used in accordance with the instruction
manual may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
^
Reorient or relocate the receiving antenna
^
Increase the separation between the equipment and receiver
^
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
^
Consult the dealer or an experienced radio TV technician for
help
I MPORTANT N OTE : FCC R ADIATION E XPOSURE S TATEMENT :
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body. To maintain compliance with FCC RF
exposure compliance requirements, please avoid direct contact to
the transmitting antenna during transmitting.
If this device is going to be operated in 5.15 ~ 5.25GHz frequency
range, then it is restricted in indoor environment only.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
We declares that this product (FCC ID: SA6P60BIABG) is limited in
2412~2462MHz by specified firmware controlled in the USA.