Hired-Hand Mega-Cool: In-Line Pump Motor Replacement - Manual (Page 2)

HIRED-HAND MFG., INC.
• 1733 Co Rd 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 265-287-2000
Manual Part Number 4802-5115 Rev. 2-06 Page 2 of 2
Remove the Motor End cap.
See Figure 5.
Remove the Pump by first loosening
the Motor Shaft. Hold the Pump Impeller while
turning the Motor Shaft with a large flat head
screwdriver. See Figure 7.
On the New Motor, loosen the Through
Bolts. See Figure 9.
Install the new Pump Motor by reversing
the above steps.
Installation complete.
Figure 9
Remove the
Thru-Bolts
STEP 3
STEP 5
STEP 7
STEP 8
STEP 9
STEP 4
Loosen but do not remove the four Motor
Thru Bolts using a ¼" Nut Driver. See Figure 6.
STEP 6
Remove the Pump. See Figure 8.
Hold the Impeller while
removing Shaft from
Pump
Figure 7 Loosen the Motor Shaft
End Cap
Figure 5 Remove the Motor End Cap
¼" Nut
Driver
Thru Bolt
Figure 6 Remove the Thru Bolts
Figure 8 Remove the Pump