Hired-Hand Emergency Back-Up and Alarms: Evolution Back-Up - Manual (Page 10)

Part No. 4801-5309 rev 10-05 Evolution Back-Up 10 of 16
12.2 Wiring the Back-Up Board Sensors and Alarm Connections
Inset A
Jumper Connection to
Enable Sensor 2
Inset B
Sensor 1 & 2 Connections
Sensor 2
Enabled
Installed – Enabled
Vacant – Disabled
Jumper
Inset A
Inset B
Inset C
NOTE: Tape Shields to
Prevent Damage.
Inset C
Back-Up Alarm Connection
Internal Wiring
Switch
Contacts
NO COM NC
BACK-UP ALARM
For a Parallel
Alarm Connection
For a Series
Alarm Connection