Hired-Hand PowerTrak Jr - Manual (Page 15)

Part No. 4801-0172 Rev 10/05 PowerTrak Jr. Page 15 of 18
11.4 Wiring PT Jr. To Electro-Mechanical Controllers
If you own a PC-OC, PC-SS, PC-D3, PC-DB, PC-LP, PC-OD, PV-TIR, or PC-PH. Your
controller wiring diagram may not match the label inside the controller. The only thing
different is the label. The internal wiring of these controllers did not change.
The picture below is the label you will see for your terminal block.
Remove the cord set from the control and remove the fuse wire from the #1 terminal
inside the controller. Connect the two units together using 5 wires. positions 1, 2, 7, 8
and GROUND. (PT Jr HOT IN connects to HOT OUT(PT Jr), AC NEUT connects to
NEUT(PT Jr), CLOSE connects to CLOSE IN(PT Jr), OPEN connects to OPEN IN(PT
Jr), connect ground from GROUND LUG of PowerTrak Jr to metal plate inside control.)
PowerTrak Jr
CONTROLLER AC IN
HOT
NEUT
.
GND. HOT OUT
CL
OSE
IN
O
PEN
IN
Br
o
w
n
Ground
Ground
Wh
it
e
Re
d
Blu
e
Or
an
g
e
Bla
c
k
Gr
ee
n
Y
e
llo
w
NO NC
COM
Open Close
PT
Hot In
AC
Neut
.