Johnson Level & Tool Mfg. 40-6250 - Manual (Page 5)

©2013 Johnson Level & Tool - Rev. 2 5
5. Operating Instructions
Sensor/Slaver
Battery Installation
The Sensor/Slaver requires 3 “AA”
alkaline batteries to operate. Locate
the battery door on bottom as shown in
photo. Loosen screws, remove cover and install the batteries with
correct polarity. Securely re-install battery door.
Power On and Off
Hold the power button for one second
to power on the Sensor/Slaver. An
audible beep and visual LED light will
confirm the power is on.
Hold the power button for one second
to power down the Sensor/Slaver. An audible beep and visual LED
power light will confirm the power is off.
Remote Control/Receiver
Battery Installation
The Remote Control/Receiver requires 3 “AA” alkaline batteries to
operate. Locate battery door, remove cover and install the batteries
with correct polarity. Securely re-install battery door.
6657H-English_Manuals 1/28/13 1:45 PM Page 5