Johnson Level & Tool Mfg. 40-6522 - Manual (Page 8)

8 ©2010 Johnson Level & Tool - Rev. 1
Instrument Usage
1. Put in Ni-MH rechargeable battery pack, or 4 “C” alkaline batteries
(not included), or connect the 6V DC battery adaptor to the unit’s
power jack.
2. Place the instrument on a platform or tripod, connecting with tripod
to the 5/8" screw thread at the bottom of the instrument.
Note: If the instrument is inclined beyond the self-leveling range,
the instrument will deliver an audible alarm. You will need to
re-position the instrument inside of its self-leveling range.
3. Press power button to turn power on, and press operation buttons
on control panel or use remote control to adjust to your desired
working status.
4. After finishing operation or before moving the instrument, turn the
power off.
7. Using the Product
Place the unit on a relatively level surface like a tripod, floor, etc
during operation.
Operating
Panels
Instrument Panel Remote Control Panel
operating panel for
calibration (located
beneath the sliding
nameplate panel of
the remote control)
3327H_Manuals 4/23/10 1:09 PM Page 8