Kushlan Products KRM160 - Manual (Page 13)

13
Graphic 7
Oil change:
6.4.5 Unscrew the oil drain plug (e) located below the oil sight glass.
6.4.6 Tip the rammer back until it is resting on its handle and allow oil to drain.
Note: In the interests of environmental protection, place a plastic sheet and a container under the machine to collect
any liquid which drains off. Dispose of this liquid in accordance with environmental protection legislation.
6.4.7 Screw in the oil drain plug (e). Torque to 54 Nm.
6.4.8 Remove filling oil plug (f ) and fill with oil. See Technical Data for oil quantity and type. Wrap the filling oil plug
with Teflon tape. Install the filling oil plug (f ). Torque to 9 Nm.
6.5 Shoe Hardware
See Graphic 8
On new machines, or after replacing shoe, check and tighten shoe hardware (a) after the first 5 hours of operation.
Inspect hardware every week thereafter.
Torque hardware as specified.
6.6 Long-Term Storage
6.6.1 Drain fuel from tank.
Graphic 8
6.6.2 Start engine and run until remaining fuel is used.
6.6.3 Remove spark plug. Pour approximately 30 ml (1 oz.)of clean SAE 10W30 engine oil into cylinder through spark
plug opening.
6.6.4 Pull starter rope slowly to distribute oil in engine.
6.6.5 Re-install spark plug.