Warnings and safety rules, Location parts description – KuulAire PACKA53 User Manual
Page 4
To obtain a current list of Replacement Parts, visit us online at www.port-a-coolparts.com.
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
USE AND OPERATION
▲
!
Symptom
Possible Cause
Possible Solution
No discharge of air
Cord is not plugged in
Make sure cord is plugged in and try to turn the unit on pressing
POWER button on control panel and remote control.
Power is not on
Check the circuit breaker or check
Circuit breaker/GFCI
GFCI reset button.
Not cooling
Water flow regulator at MIN setting Change the water regulator setting to MAX.
Low/No water
Check Water
Odor emission
Brand new unit
Brand new cooling pad will initially have an odor which will dissipate
within a week of initial use.
Old unit with algae
If the unit is not new, there may be an algae issue
– replace the pad and maintain regularly.
Water droplets coming
Calcium saturated water
Drain water, deep clean and clean the cooling pad.
out of air outlet
Cooling pad installed wrong
Adjust pad in back and install pad securely in place.
Clogged cooling pad
Cooling pad may need to be replaced.
The unit will not respond
Damaged PCB
Try with remote control. If the unit responds, PCB board fasteners
loose. If neither control panel nor remote control command works,
PCB board damaged - contact service technician.
Moisture in PCB
Try using remote control to see if the unit responds. If the unit
responds briefly, likely cause is the moisture in the PCB. Turn off
unit by unplugging it from the power. Drain, clean and dry the unit,
possibly replace the pad. Refill it with fresh water.
Remote control batteries
Check Batteries
Unit is making noise
Calcium build up in blower
Deep clean the unit -remove calcium debris.
Loose pump impeller cover
Securely fasten the impeller cover in the reservoir
Water Flow Regulator knob is at Close the water distribution compartment cover.
MIN position and the water
distribution compartment cover
is open
The unit will not
Damaged PCB
Damaged PCB - contact service technician.
turn off
Remote Control Batteries
Check batteries
1. Control Panel
2. Water Flow Regulator Knob
3. Water Level Gauge
4. Rear Cover
5. Water Fill Door
6. Base
7. Drain
8. Cord Wrap
9. Casters
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
USE AND OPERATION
▲
!