AEG 3210 BU - Manual (Page 27)

27
TO REMOVE THE WIREWORK
RUNNERS
The wirework runners in both ovens can be removed
for cleaning.
1. Remove all shelves and furniture from the oven.
2. Hold the wirework at the bottom, unclip from the
cavity side an gently pull towards the centre of
the oven.
3. Support the side panel at the bottom.
4. Unhook the runner and side panel at the top and
remove from the cavity.
5. To replace, ensure the side panel is assembled
on to the wirework runner before hooking it back
into the oven.
Ensure that the wirework runners are firmly
in place before refitting the oven shelves.
CLEANING THE SHELVES, WIREWORK
RUNNERS AND OVEN FURNITURE
Soak the oven shelves, wirework runners and grilling
grid in hot soapy water if heavily soiled, they will then
clean more easily. If the shelves are heavily soiled a
soap impregnated steel wool pad can be used.
The grill pan and meat tin can be cleaned using a
soap impregnated steel wool pad.
All items of grill and oven furniture are dishwasher
safe with the exception of the grill pan handle.
CARE OF STAYCLEAN SURFACES
The roofs and sides of both ovens and the main oven
back panel are coated with a Stayclean finish. They
should not be cleaned manually.
Aerosol cleaners must not be used on Stayclean
surfaces and must not come into contact with
elements or the door seal, as this may cause
damage.
During normal use the Stayclean coating will become
splashed with fats and food residues. By running
the oven without food, the Stayclean surfaces burn
off any soilage. Regular use of the oven cleaning
cycle will help to keep the panels in good condition.
See page 28.
CAVITY
CENTRE
SIDE PANEL