Audiovox PRESTIGE PMC-50 - Manual (Page 7)

CD CHANGER ERROR CODES
If a problem should develop while operating the CD changer, the
following error codes may be appear on the display panel.
NO MAG:
NO DISC:
1 ERROR:
**FULL**:
NO FILE:
Indicates that there is no magazine loaded in the CD
changer.
Indicates that there are no discs loaded in the CD
magazine in the changer.
Indicates an error in the laser reading the disc in slot
#1 of the magazine (“2 ERROR” for disc in slot #2,
etc.). Eject the magazine, remove the disc and
make sure it is clean, undamaged, and loaded
correctly (label side up). Clean and re-load the
disc(s) as appropriate and check for proper opera-
tion or try another disc.
Indicates that all of the 110 Disc ID memory loca-
tions have been used. If you wish to enter a new Disc
ID, it will be necessary to delete one of the existing
ones as described in the programming instructions.
Indicates that the CD changer to which the unit is
connected does not incorporate the necessary cir-
cuits to support the Disc ID feature.
6
tion by pressing and holding the button for longer than 4
seconds.
2. If you attempt to program more than 110 Disc ID’s, the display
panel will indicate “**FULL**” and you will need to delete an
existing Disc ID to make room for a new one. To do this, first
press and hold the Display Call button
bl
for 4 seconds to enter
the programming mode. Momentarily press the Play/Pause
button
2
and a programmed Disc ID name will appear and flash
on the display panel. Within 5 seconds of the flashing name
appearing, use the Disc Select button
4
to sequence through
all names in the Disc ID memory locations until the desired
name for deletion appears. While the name is still flashing on
the display panel, press and hold the Play/Pause button for 2
seconds until the name disappears and the indication
*DELETE* appears. The selected Disc ID name has now been
deleted from the changer memory. Continue this procedure to
locate and delete other Disc ID names as desired. When you
have finished deleting the desired number of Disc ID names,
press and hold the Display Call button
bl
for 2 seconds or simply
wait 5 seconds for the display to stop flashing and return to
normal display function. You can now program new Disc ID
names as desired up to the number of deleted items.