Lincoln Electric IM408 MAGNUM SG SPOOL GUN - Manual (Page 12)

SPOOL GUN GUN CABLE ADAPTER CABLE
CONTROL CIRCUIT DIAGRAM (ABOVE CODE 9100) FOR SP-150
6. Connect spool gun power cable to (+) stud
terminal on SP-150. Disconnect any lead
already attached there.
7. Connect work lead to (–) stud terminal on
SP-150 if not already connected there. Close
left side door.
9. Connect regulated argon gas supply to gas
inlet fitting on rear panel of SP-150.
8. On front control panel of SP-150:
8A. Connect spool gun gas line to gas outlet
fitting.
8B. Set welding voltage. (1)
8C. Set wire feed speed. (1)
(1) See Part B, “Test Weld Settings".
5
NOTE: Connector pinouts show view of mating connector sides.
NOTE: Connector pinouts show view of mating connector sides.
SPOOL GUN GUN CABLE ADAPTER CABLE & WIRES
CONTROL CIRCUIT DIAGRAM (BELOW CODE 9100) FOR SP-150