Lincoln Electric IM408 MAGNUM SG SPOOL GUN - Manual (Page 17)

10
FITTING THE ELECTRODE WIRE (Cont.)
If the spool brake is applying too much tesion
on the spool :
• Remove the spool brake assembly and the
spool of wire.
• Remove the spool hub nut and the lock
washer.
• Remove the spool hub bolt.
• Remove the lock washer from under the
bolt head.
• Place the removed lock washer under the
spool hub nut.
• Reassemble all components execpt for the
spool cover.
10. Obtain contact tip sized to match wire
selected. Slip contact tip over wire and
screw into diffuser. Tighten securely.
11. Push on gas cone and cut off wire close to
end of contact tip.
CAUTION: BE CAREFUL WHEN PUSHING ON
GAS CONE. WIRE END COULD PUNCTURE YOUR
HAND.
12. Reinstall spool cover with cover slot over
plastic tube and secure.
SPOOL COVER
SPOOL BRAKE
ASSEMBLY
SPOOL HUB NUT
SPOOL WASHER
SHIM WASHERS
FLAT WASHER
LOCK WASHER
SPOOL HUB BOLT
INCREASING BRAKE TENSION ON THE SPOOL
SPOOL COVER
SPOOL BRAKE
ASSEMBLY
SPOOL HUB NUT
SPOOL WASHER
SHIM WASHERS
FLAT WASHER
LOCK WASHER
SPOOL HUB BOLT
DECREASING BRAKE TENSION ON THE SPOOL